[Elecraft] K3 beta firmware revision 3.11 now available

[wayne burdick]

K3 beta-test firmware revision 3.11 (with DSP rev. 2.15) is now 
available. For details, see the release notes below.

Please send any problem reports to k3support at elecraft.com. For 
instructions on how to load beta firmware, please see:

        http://www.elecraft.com/K3/k3_software.htm

We recommend that you use the latest revision of K3 Utility, which can 
also be found on the K3 software page.

73,
Wayne
N6KR

* * *

MCU 3.11 / DSP 2.15  April 18, 2009

Misc. Improvements:

* DATA SUB-MODE NOW SAVED/RESTORED CORRECTLY: On power up and on some 
band changes, the data sub-mode (e.g. FSK D) was getting lost.

* ERROR TONE PITCH PROBLEMS FIXED: The sidetone pitch was getting 
changed by certain error conditions and when doing TUNE.

* SWITCH TONES NO LONGER GETTING STUCK ON: In AM mode with wide AM 
bandwidths selected, tapping HI/WIDTH or LO/SHIFT could leave the 
switch feedback tones on, or omit the second switch tone entirely.

* BALANCE CONTROL MOVEMENT JUST AFTER POWER-UP NOW OK: Someone noticed 
that if you power up the rig with the sub turned on, then move BALANCE 
(SUB AF) before moving AF GAIN, the main receiver AF would be lost 
temporarily.

---

http://www.elecraft.com