[Elecraft] [K3] K3 : no sound from speaker, no rx

[chen dave]

You can also change the menu setting to enable the SUB-RX, you will get
error
message when you power on. Don't worry about that. At this time you should
get
the audio back.

73s David , BA4RF

On Fri, Apr 3, 2009 at 12:40 PM, hb9brj <hb9brj at gmail.com> wrote:

>
>
> Guys, i just completed the initial test and calibration.
> I hear no sound from the speaker or headphone, the rx shows no s-meter
> action when i transmit a signal with an other tx.
> There are no ERR-Messages.
>
> The radio ist equipped with the Transverter-Interface, I still have to
> install the Sub-RX and KPA100.
>
>
> Experienced the same when building my K3 in August 2008.
>
> It seems that the AUX-DSP board (used by Sub-RX), when installed during the
> front panel assembly, blocks the entire system as long as the Sub-RX itself
> is not installed. Support told me to remove the AUX-DSP board, do the
> initial tests and only reinstall it before adding the Sub-RX.
>
> Markus
>
> --
> View this message in context:
> http://n2.nabble.com/K3-%3A-no-sound-from-speaker%2C-no-rx-tp2578094p2578924.html
> Sent from the [K3] mailing list archive at Nabble.com.
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>