[Elecraft] [K2] SSB power problem

[Don Wilhelm]

Allen,

Set SSBC to 3-1 and try it again.  I believe you will be pleasantly 
surprised.  You may even be able to move the SSBA parameter to 1 if you 
set the compresssion higher.

73,
Don W3FPR

Allen Wisbey wrote:
> Ok, smart people, I am having a problem and I know not where to look...
>
> I have a newly assembled K2 with DSP, NB, SSB, 160mtr, 60 mtr options, 
> MH2 mike. All testing went fine throughout.
>
> I am not able to get any ALC indication unless I yell into the mike, 
> whistling sometimes will flicker one bar, if I am very loud.
> Whistling into the mike gives different power output results on a per 
> band basis. K2 set for 10 watts, readings taken at either end of phone band.
> SSBA set to 3
> SSBC set to 1-1
>
> 160 mtrs nets 0.3 and 0.5 watts
> 80 mtrs nets 5 and 7 watts
> 40 mtrs nets 7 watts
> 20 mtrs nets 6 watts
> 17 mtrs nets 3 and 5 watts
> 15 mtrs nets 4 watts
> 12 mtrs nets 1 watt
> 10 mtrs nets 0.5 to 0.7 watts
>
> It should be noted that CW mode works fine. The lowest output was 6 
> watts at the low end of 160 mtrs, 12 mtrs (both ends of band), and the 
> low end of 10 mtrs.
>
> I have the resistor across pins 1 and 6 of the mike connector, all 
> jumpers are in place (straight across).
>
> Bad mike?
> Any ideas?
>
> 73 de Allen, W1SBY
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.0.238 / Virus Database: 270.11.38/2037 - Release Date: 04/02/09 06:09:00
>
>