[Elecraft] K3 beta firmware rev. 3.06: all-mode squelch; SSB power control improved

[KC2UEE]

Thank you Wayne!  All-mode squelch sounds great.  Can't wait to try this
when I get home.

73,
James K3JPS

On Wed, Apr 1, 2009 at 7:23 PM, wayne burdick <n6kr at elecraft.com> wrote:

> K3 beta-test firmware revision 3.05 (with DSP rev 2.12) is now
> available. For details, see the release notes below.
>
> Please send any problem reports to k3support at elecraft.com. For
> instructions on how to load beta firmware, please see:
>
>      http://www.elecraft.com/K3/k3_software.htm
>
> We recommend that you use the latest revision of K3 Utility, which can
> also be found on the K3 software page.
>
> 73,
> Wayne
> N6KR
>
> * * *
>
> MCU 3.06/DSP 2.12  April 1, 2009
>
> * SSB POWER CONTROL: Decreased time that SSB power output takes to
> reach target when PWR control adjusted. Also eliminated drive level
> change when ATU TUNE is used.
>
> * SQUELCH IN ALL MODES: To use this feature, locate CONFIG:SQ MAIN,
> then tap '1' until you see "ALL".
>
> To use the SUB RF/SQL pot to control both main and sub squelch, set
> CONFIG:SQ MAIN to =SUB POT. (In this case, MAIN RF will control both
> main and sub RF GAIN.)
>
> If you want independent control of main and sub squelch, set SQ MAIN
> and SQ SUB to numeric values (0 opens the squelch all the way). SQ MAIN
> and SQ SUB will then be fully independent. They can be assigned to
> programmable function switches if you use them frequently. (In this
> case MAIN RF GAIN and SUB RF GAIN are independent, using the lower
> concentric pots.)
>
>
> ---
>
> http://www.elecraft.com
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>