[Elecraft] K3 and PR6 question

[Andy GD0TEP]

OK Bud, that answers that question then...  thanks.

73 Andy
http://www.gd0tep.com


-----Original Message-----
From: Bud Semon N7CW [mailto:n7cw at cableone.net] 
Sent: 02 April 2009 14:57
To: 'Andy GD0TEP'; elecraft at mailman.qth.net
Subject: RE: [Elecraft] K3 and PR6 question

Hi Andy,

There was a fairly long discussion between Wayne, W0MU and myself on this
subject, mostly on the reflector.  The answer was no - you can't use the PR6
(as installed on the radio) inline on the 2nd receiver to monitor 6M while
operating on other bands.

73, Bud  N7CW

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Andy GD0TEP
Sent: Thursday, April 02, 2009 5:57 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 and PR6 question

Hello to the group.

I must be missing something in the manual... 

If I use the K3 (and 2nd receiver) with the radio TX on the main, but RX on
the sub receiver that is connected to the antenna via the BNC RX antenna
(with the SUB indicated on the display) is the PR6 pre-amp in line with the
sub receiver or not?

73 Andy
http://www.gd0tep.com


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html