[Elecraft] KRX3 received

[Ron D'Eau Claire]

Good idea Mike. 

Interesting about the clock. Did you install the cover over the clock
battery before installing the KRX3 module? 

If so, did you make sure the cover didn't slide between the battery contact
and the battery itself (Fig 38 pg 33)?

If you forgot the cover, you may have a short from the + (outer rim) of the
battery and the bottom of the KRX3 module. In that case you may need a new
clock battery.

Ron 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of AD6XY
Sent: Thursday, September 25, 2008 3:26 PM
To: elecraft at mailman.qth.net
Subject: RE: [Elecraft] KRX3 received



I did read the preparing for operation section. That is how I knew to do the
calibration of the synth and that I needed to set up the filters. These took
a while because I had to remember how to do each task, having last done it
last March. Setting antennas comes later and is not a tick-off item. What
would help most is a simple list without any descriptive text, just to get
everyone started. There is currently no quick-start guide.

On a related issue, I appear to have lost the date and time in doing the
KRX3 installation. I am sure I set it OK before. Time was reset to midnight
and the date was showing 00.00.00.

Mike


-- 
View this message in context:
http://n2.nabble.com/KRX3-received-tp1118997p1119448.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com