[Elecraft] Another Possible 2.38 anomaly

[Brett Howard]

I think I may have noticed another small bug in 2.38.

If you hold REV and adjust the frequency the release rev the new
frequency sticks in VFO B.  But if you hold rev and adjust the filter
width then release REV that does not get copied into the VFO B area.
The only way to do this is to either switch to B and adjust then
switch back or to use the B SET feature.  Pressing mode while holding
REV does nothing but its not like one can easily do that with one
hand.  Would be a fun one to have "on the list" yet down a ways to be
able to do that some day.  I'd rather have the ability to adjust
filter widths and what not during TX first.

On Sun, Sep 21, 2008 at 5:13 AM,  <williamsonr at pbtcomm.net> wrote:
> I now notice that in CW mode, on any band, switching from the 2.7K filter to the 1.8K filter (xfil 2, xfil 3) shows no change in the passband filter graphic (remains at a total width of one bar past the tic marks)? Adjusting the Width control will change the graphic width.  In SSB mode switching between these xtal filters results in a corresponding change (narrowing) to the graphic.  Anyone else notice this?
>
> 73,
> Rodger
> N4NRW
>
> filters
> FM
> 2.7K
> 1.8K
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>