[Elecraft] K3 output power unstable

[GW0ETF]

Bjorn wrote:
> 
> I am right now in the middle of the SAC contest when I notice that the K3
> has a problems keeping output power stable. I noticed some excessive high
> output from the amp when investigating I found that my K3 set to drive the
> amp with between 20-30 watt output depending on band, delivers
> substancially
> more. Ouptut power pulsate between nothing and full power, delivering more
> than 100 watts in bursts into the amp (designed for 30W input).
> 
> The problem is easiest to reproduce on 80 meters, but I am sure I saw the
> power wobble a few seconds b4 stabilizing on higher bands to. Even when
> the
> radio has cooled down to a PA temp of 34C the problem is there.
> 
> I think I read somthing about a similar prioblem somewhere, would
> apreciate
> any leads that I might help to narrow down and eliminate the problem.
> 
> 73 de Björn /SM0MDG (SE0X in SAC)
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

Bjorn,

I posted about this very problem a couple of months ago but had virtually no
feedback so it's interesting to hear of someone else being affected. As you
say the power would drop quite suddenly then come back up; when running an
amp it once went right up to ~100w even though set for about 35w - it
tripped the amp....

Seems to do this on phone too but cw is easiest to see when it's happening.
To be honest it has hardly happened to me at all recently and I wonder if
you have the latest firmware installed. I did contact Elecraft support and I
seem to remember they said it was an AlC control software problem and to
keep downloading the latest firmware which would eventually sort it, and as
I say it seems much better now here. However the other day I was on phone
and the power was all over the place; it then started giving me TXG Error
messages and I had to do the 5 and 50 watt power output config from start to
finish which seemed to fix it.

Good luck in the contest - family duties here else I would be giving away
some points for you....

73, 

Stewart Rolfe, GW0ETF (K3 145)
-- 
View this message in context: http://n2.nabble.com/K3-output-power-unstable-tp1106588p1106667.html
Sent from the Elecraft mailing list archive at Nabble.com.