[Elecraft] K3/100 # 1670 lives

[Joe Subich, W4TV]

> I just assembled K3/100 sn1617 - it also came with KPA3 manual Rev D, 
> Jan 2008. No errata in my box. Also, no errata on your web site.

I just finished 1450 with KRX3.  All of the manuals in the box were 
one revision old.  I printed copies of the most recent manuals on the 
web and worked from them. 

Next project, installing the KRX3 in S/N 622. 

73, 

   ... Joe, W4TV 
 



> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jerry Flanders
> Sent: Wednesday, September 17, 2008 11:39 PM
> To: Ron D'Eau Claire; elecraft at mailman.qth.net
> Subject: RE: [Elecraft] K3/100 # 1670 lives
> 
> 
> I just assembled K3/100 sn1617 - it also came with KPA3 manual Rev D, 
> Jan 2008. No errata in my box. Also, no errata on your web site.
> 
> Jerry W4UK
> 
> At 04:59 PM 9/17/2008, Ron D'Eau Claire wrote:
> >All of the acorn nuts go on the outside of the fan panel, Gary.
> >
> >The new acorn nuts were introduced in May, 2008, and their use was 
> >documented in Errata D3, dated May 7,2008 to the KPA3 manual.
> >
> >The manual was subsequently updated to Rev E to include the errata 
> >items. Rev E was released June 17. The proper installation 
> of the acorn 
> >nuts is covered on Page 14 and shown in Figure 13.
> >
> >If you got a Rev D manual without the errata, that was a mistake.
> >
> >Ron AC7AC
> >
> >-----Original Message-----
> >
> >It is now alive and well after about 10 hours of build and 
> >calibration/testing time.  I did find a few very minor problems with 
> >the assembly instructions that I will share with 
> Elecraft.particularly 
> >with the Fan assembly as the two bottom center acorn nuts interfered 
> >with the relay of the KPAIO3 board and needed to be put on the 
> >outside.the instructions are unclear since the screws and nuts have 
> >been changed.  All in all the build went exactly as the 
> manual said.  
> >My hat's off to the guys at Elecraft for a very fine kit.  
> 73 and see 
> >you on topband.de gary, kd9sv
> >
> >_______________________________________________
> >Elecraft mailing list
> >Post to: Elecraft at mailman.qth.net
> >You must be a subscriber to post to the list.
> >Subscriber Info (Addr. Change, sub, unsub etc.):
> >  http://mailman.qth.net/mailman/listinfo/elecraft
> >
> >Help: http://mailman.qth.net/subscribers.htm
> >Elecraft web page: http://www.elecraft.com
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com