[Elecraft] K3 Display "T" Symbol

[Robert Brandon]

Oops, there it is on page 29.

Tone encode is set up by holding PI TCH.
Rotate VFO A to select a CTCSS tone
frequency (or the European repeater access
tone, 1750 Hz). Use VFO B to turn tone encode
on (PL TONE) or off (PL OFF).

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Robert Brandon
Sent: Monday, September 15, 2008 3:44 PM
To: 'Roger'; 'elecraft'
Subject: RE: [Elecraft] K3 Display "T" Symbol

Manual, Page 12:  "T indicates FM/tone, or CW/data text decode".

Hmmm.  I don't think there's anything in the menus that allows for setting a
CTCSS tone.  Maybe that will be added later.  


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Roger
Sent: Monday, September 15, 2008 3:20 PM
To: elecraft
Subject: [Elecraft] K3 Display "T" Symbol

What does the letter "T" mean when it appears in the lower right hand corner
of the display?
                                                Roger K8RS
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com