[Elecraft] K3 Front Panel Problem

[Chris G3SJJ]

Having successfully installed the KRX3 I have a small problem on the 
front panel which I think is due to either a poor ground connection or a 
connector not fully mated.

On power all display segments show, which I can't remember seeing 
before. Initially I could then see a lot of segments which cleared when 
I pressed on the FP. Now I am seeing less unwanted segments which clear 
when I press the left hand side of the FP, just to the rioght of the 
headphone jack.

Before I take the FP off again has anyone an ideas where I should 
concentrate on? Obviously around the left hand side but anything in 
particular!

The 2nd Rx sounds great.

Chris G3SJJ