[Elecraft] K3 DSP Problem

[Richard Thorne]

I solved my problem.

I kept uploading until the DSP1 took, must have taken 10 times to get it 
done, weird.

Rich - N5ZC

Richard Thorne wrote:
> I have a factory built K3.  I have been downloading firmware updates 
> when ever a new one comes out, mostly without issues.  Occasionally I 
> would have to do the upload again to get the DSP1 upload to work.
>
> Recently after uploading MCU 2.38, FPF .02 and DSP1 1.9 I have a problem.
>
> When I bring up the K3 Utility program it shows DSP1 having version 
> 00.00 installed.  I have attempted several times to upload 2.38 as 
> well as uploading prior versions such as 2.37, 2.34 ect.
>
> However, the installed version of DSP1 continues to show 00.00 and I 
> have no audio.
>
> I also get errors E000202 and ERR DSE.
>
> Any ideas what may be going on?
>
> Thanks in advance.
>
> Rich - N5ZC
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com 
> Version: 8.0.169 / Virus Database: 270.6.19/1663 - Release Date: 9/9/2008 7:04 PM
>
>