[Elecraft] K3 Beta Firmware, Rev. 2.38 -- fixes "RIT CLEAR" remote-control command

[wayne burdick]

K3 beta-test firmware revision 2.38 is now available. In revision 2.37, 
the "RIT CLEAR" PC command ("RC;", or %O from Writelog, etc.) was 
sometimes doing the equivalent of a "long-hold" of the CLR switch, 
which copies the RIT offset to VFO A before clearing RIT.

Please send any problem reports to k3support at elecraft.com. For 
instructions on how to load beta firmware, please see:

   http://www.elecraft.com/K3/k3_software.htm

73,
Wayne
N6KR


---

http://www.elecraft.com