[Elecraft] KRX3 Success

[k1tl at cox.net]

I found out why I was not hearing any signals on the KRX3...when I first
setup the KRX3 filters, I installed it in slot 1 and then changed it to slot 2.
I configured slot 2 but forgot to disable slot 1...duh ! ! !

W1EM suggested I go to the K3 Utility program and see all the filters and
that is where I found that FIL1 was still enabled. Since I had both setttings
the same, it was looking at slot 1 for the 2.7KHz filter.

I think Elecraft should put that in their K3 and KRX3 manual, to use the
K3 Utility Program to setup the filters, as it is PAINLESS ! ! ! !

Now I am in the corner wearing the Dunce Cap ! !

Tom/k1tl...