[Elecraft] KRX3 and No Signals in Headset

[k1tl at cox.net]

Finally got the KRX3 up and running after Wayne and Gary suggested I
look at the 27 ohm resistor I soldered over R91...boy, am I red faced on
this one as one leg had a "cold solder" joint on it. Guess didn't let the
pad get warm enough to "tack" the leg down on the PC via.

That solved the ER PL1 problem.

Now the only thing I am not getting is signal(s) on the right headset. I
tried everything so far but must be missing something real simple.
CONFIG SPKR+PHONE: NO
CONFIG SPKRS: 1
KRX3: ANT=BNC ( I did not install any of the cables (ATU or BNC))

Tried the SUB on, then BSET and antenna selected was MAIN but 
still nothing from the right headset, just noise !

If this is something real simple, I am going to wear a dunce cap for the
remainder of the year !

Tom/k1tl...