[Elecraft] K2 - Toroids

[Don Wilhelm]

Ron,

The most important parameter is the number of turns and the core type.  
The inductance shown in the schematic may not be correct for all cases.  
That particular RFC used to be a molded inductor and was changed to a 
toroid, but the schematic was apparently not updated with the new value.
In all cases, the values shown in the text are correct.  In this case it 
is the number of turns that are important. 

You may update your schematic with your measured value if you wish.

73,
Don W3FPR

Ron McCurdy wrote:
> I just wound my first toroid for the K2.  It is supposed to be RFC14,
> 18microhenries, 10 turns.  I measured the inductance with my LC Meter IIB
> and it measures 31 microhenries.  Is this okay?  Should I remove turns until
> it is correct???
>
>  
>
> Ron
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com 
> Version: 8.0.169 / Virus Database: 270.6.16/1651 - Release Date: 9/4/2008 6:57 AM
>
>