[Elecraft] K3 Beta Firmware, Rev. 2.37 -- eliminates DSP errors when upgrading

[wayne burdick]

K3 beta-test firmware revision 2.37 is now available. This revision 
should eliminate spurious DSP error messages during firmware loads (ERR 
DSE, etc.). Other details appear below. Be sure to use the latest 
revision of K3 Utility to do the downloads.

Please send any problem reports to k3support at elecraft.com. For 
instructions on how to load beta firmware, please see:

   http://www.elecraft.com/K3/k3_software.htm

73,
Wayne
N6KR

* * *

MCU 2.37 / DSP 1.90, 9-2-2008

* FIRMWARE UPGRADE PROCESS IMPROVEMENT: When upgrading firmware,
MCU and DSP code versions may temporarily become incompatible,
resulting in error messages during loads. These spurious errors
are now suppressed, resulting in a cleaner upgrade process,
especially when upgrading from much older revisions.

* SUB/MAIN AF GAIN EQUALIZED.

* VCO CAL improved to make synthesizer alignment easier.


---

http://www.elecraft.com