[Elecraft] [K3] Harmonic Distortion
Jim Brown
jim at audiosystemsgroup.com
Tue Sep 2 16:15:44 EDT 2008
On Tue, 2 Sep 2008 11:36:19 -0700, Mike Scott wrote:
>I know that LIN OUT and AGC settings might interplay,
Yes.
>so for what it is
>worth I run LIN OUT gain at 3, AGC SLP = 10, AGC THR = 6. Other parameters
>are default.
I haven't studied what the ideal settings are, but I would follow Lyle's
guidelines for strong signal conditions.
>My sound card gain is now set to maximum. I believe it would be a lot
>happier if there was more drive. I think maximum soundcard gain with low
>signal drive makes what ever noise pickup that exists on my cables more
>obvious as I have a lot of spikes (60-hz multiples) showing outside the
>filter pass band just 18 dB below the general tops of the in-band noise
>spectrum.
See my Power Point on how to kill this noise by bonding together the
chassis of the computer to the chassis of the rig. It's easy, cheap, and
very effective.
http://audiosystemsgroup.com/HamInterfacing.pdf
and the same stuff as text in
http://audiosystemsgroup.com/RFI-Ham.pdf
73,
Jim K9YC
More information about the Elecraft
mailing list