[Elecraft] KRX3 no audio

[Carl Clawson]

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Nelson 
> Wittstock
> 
> I just installed my new KRX3 and I do not have any audio.  
> There is no hissing sound as there is when I use the main 
> receiver.  In the Config menu I have set ANT=BNC as I 
> installed the TMP cable with the BNC connector to allow me to 
> do diversity work later.  In BSET I have the ANT set to MAIN. 
> When I tap the SUB button the SUB icon on the screen lights 
> up.  SUB RF gain is full clockwise.  What setting do I need 
> to set or correct?  Is it possible that it isn't plugged in 
> correctly?  The two long screws that go through the receiver 
> mated easily with the standoffs below so I don't think it 
> could be displaced.

This sounds like what happened to me. I was set to CONFIG:SPKRS 2 but I
unplugged my stereo speakers during the installation and then began testing
using the internal speaker. Make sure you set CONFIG:SPKRS 1 if you are
trying to do that. The internal speaker only hears the main RX if you're set
for stereo.

73 & HTH
Carl WS7L