[Elecraft] K3 Firmware 2.58

[Bill Johnson]

Julian,

Here's what's in the command:  PC0500;PC;DS;

I tried it again and I get the same thing.  The power cannot be adjusted
with the front panel dial past 12 watts.  


Bill


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Julian, G4ILO
Sent: Friday, October 31, 2008 12:54 PM
To: elecraft at mailman.qth.net
Subject: RE: [Elecraft] K3 Firmware 2.58




Bill Johnson-9 wrote:
> 
> Julian,
> 
> I set the power by double clicking in the software.  I made no changes to
> the config settings so this was definitely a software created change. 
> 
> Bill
> 
> 
I have never disabled the PA intentionally from the menu either.

Strange. All the shortcut does is cause the commands: PC0500;PC;DS; to be
sent to the radio. You can right-click it and see the commands that are
sent, and change them if you want to.

The PC0500; sets the power to 5W. The PC; causes the power level to be
reported back to the program straight away and the DS; causes the status
information to be updated.

Only the first command is necessary to set the power. The others are just so
you can see the effect immediately. Nothing that is sent should have the
effect of disabling the PA permanently.

-----
Julian, G4ILO. K2 #392  K3 #222.
http://www.g4ilo.com/ G4ILO's Shack   http://www.ham-directory.com/ Ham
Directory    http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3 
-- 
View this message in context:
http://n2.nabble.com/K3-Firmware-2.58-tp1437773p1437924.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com