[Elecraft] K3 - KRX3: AF Gain

[Mitch Wolfson DJØQN]

Bill,

It turned out to be a simple configuration problem as I had suspected.

The KRX3 had lost the antenna setting when I disabled and reenabled it to 
fix the AF gain problem, so I only had to use BSET and tap [ANT] to choose 
the same ANT again as VFO A.

Now all is well!

Thanks to everyone that responded!

73,
Mitch DJØQN

----- Original Message ----- 
From: "Bill W4ZV" <btippett at alum.mit.edu>
To: <elecraft at mailman.qth.net>
Sent: Thursday, October 30, 2008 1:19 PM
Subject: Re: [Elecraft] K3 - KRX3: AF Gain





Mitch Wolfson  DJØQN wrote:
>
>
> Now I notice that my KRX3 sensitivity is much lower than the main
> receiver,
> which wasn't the case when I installed it. I will try to figure that
> problem
> out on my own or otherwise contact support.
>

Check your XFIL gain settings in the SUB vs MAIN.  If using a CW filter, it
could be you are not compensating for the additional insertion loss of
narrow filters in the SUB.

73,  Bill  W4ZV



-- 
View this message in context: 
http://n2.nabble.com/K3---CQWWSSB-Contest-tp1377420p1398122.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com