[Elecraft] K3 - KRX3: AF Gain

[Stewart Baker]

Make sure that the KRX3 is fully mated with  the SUBIN board 
connectors.

73
Stewart G3RXQ
On Wed, 29 Oct 2008 09:02:50 +0100, Mitch Wolfson  DJØQN wrote:
> Hi Lyle,
>
> Thanks for the tip.....I am using 2.46, and it didn't work until 
you pointed
> me in the right direction.
>
> Since I had the AF Gain set to HI before I installed the KRX3, I 
now
> disabled the KRX3 and changed AF to LO. Then I enabled the KRX3 
and changed
> AF to HI afterwards, and that solved that problem.
>
> Now I notice that my KRX3 sensitivity is much lower than the 
main receiver,
> which wasn't the case when I installed it. I will try to figure 
that problem
> out on my own or otherwise contact support.
>
> Thanks again & 73,
> Mitch DJØQN
>
> ----- Original Message -----
> From: "Lyle Johnson" <kk7p at wavecable.com>
> To: "Mitch Wolfson DJØQN" <dj0qn at arrl.net>
> Cc: <elecraft at mailman.qth.net>
> Sent: Wednesday, October 29, 2008 1:43 AM
> Subject: Re: [Elecraft] K3 - KRX3: AF Gain
>
>
>> Hello Mitch!
>>
>>> I have the main receiver's AF Gain set to HI, but I can't find 
a way to
>>> enable that function on the KRX3. Am I missing something, or 
is this a
>>> feature request?
>>>
>> Setting the AF GAIn HI or LO in the CONFIG menu sends the 
appropriate
>> commands to both main and sub receivers if the KRX3 is 
installed and
>> enabled.
>>
>>> With the main receiver on HI, the difference between the two 
receivers is
>>> too great to be able to hear very well on the KRX3, at least 
for the hard
>>> of hearing.
>>>
>> The gain imbalance was fixed in firmware release 2.36/1.90.  I 
also
>> confirm it is fixed in the latest development release.  I have 
not
>> specifically checked this in any interim releases.
>>
>> Which firmware do you have loaded in yhour K3?
>>
>> 73,
>>
>> Lyle KK7P
>>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com