[Elecraft] KPA100 Resistance Test Failure

[R. Kevin Stover]

Which radio are we talking about?


dberkley wrote:
> In the Alignment and Installation section of the Rev E manual I may have a
> problem with the resistance tests in the table on page 43.
> 
> J3 resistance to ground, after about 20 seconds is okay (6.6K which is >
> 5K).  However, Q1 and Q2 collector to ground start at about 30K but decrease
> over a similar time to only about 8K (significantly less than the required
> 10K).
> 
> Also the final test, D13 cathode to ground increases to about 9.4K after a
> similar time (which is still less than the require 10K).
> 
> Any thoughts on what might be wrong or are these reading okay to move
> forward to the powered test?  I'd rather not fry things before I even get
> started!  Thanks for any help.

-- 
R. Kevin Stover, ACØH
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: multipart/alternative
Size: 0 bytes
Desc: not available
Url : http://mailman.qth.net/pipermail/elecraft/attachments/20081028/3bc57304/attachment.bin
-------------- next part --------------

No virus found in this outgoing message.
Checked by AVG - http://www.avg.com 
Version: 8.0.175 / Virus Database: 270.8.4/1751 - Release Date: 10/27/2008 10:44 PM