[Elecraft] Solved: How to communicate with the K3 using N1mm

[Dick Dievendorff]

The K3 doesn't change its baud rate without some front panel action or PC
command. The K3 Utility determines the K3's baud rate by trying each of the
four supported speeds.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jack Colson
Sent: Monday, October 20, 2008 2:35 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Solved: How to communicate with the K3 using N1mm

Well it is working, i presumed that the K3 would auto-baud with what 
ever bit rate it was receiving.  Not so, mine was sitting at 9600.  Once 
the two were set to agree, BINGO!  Thanks to all - sorry I should have 
looked at the config -rs232 on the K3 before asking for help.

73
Jack, W3TMZ 

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com