[Elecraft] How to communicate with the K3 using N1mm via USB?

[W2XB]

Hello Jack,
I am using serial to USB cables with the K3 and N1mm and also Winkey.
all working fb. Do you have the same baud rate set on the K3 as in n1mm?
If the utility software works with the serial to USb cable it should work.

Don...w2xb





Jack Colson wrote:
> 
> OK I give up, I have two USB to RS-232 interface cables: 1) the Elecraft 
> and 2) a Radio shack.
> Each cable works, I can see the comm ports listed whenchecked with 
> device manager/ports when they are connected to the PC.
> I use the Elecraft cable for firmware downloads to the K3 successfully.
> 
> Communicating with my Yaesu FT-100D using either cable and N1MM  works 
> perfect.  Subsitute the K3 and nada.  There must be a simple solution to 
> this situation!
> What am I missing?  Help !
> 
> Using a WIN98 PC which has a standard RS-232 port and N1MM  and K3 work 
> perfect.
> 
> Thank you,
> 73
> Jack, W3TMZ 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://n2.nabble.com/How-to-communicate-with-the-K3-using-N1mm-via-USB--tp1356522p1356797.html
Sent from the Elecraft mailing list archive at Nabble.com.