[Elecraft] N1MM and K3 interface ?

[Arie Kleingeld PA3A]

Hi Ed,

Yes I know. I've had solutions like that before I got myself a Winkey
because of the stuttery CW from N1MM. I've keyed and PTT'ed my FT1K
through parallel and serial ports, depending on computer available hi.
But with slower computers in a network and a couple of thousands qso's
during the contest the bad CW of N1MM became annoying.

The winkey solution works great, also with old computers.
Used it today on the WAG contest.

73
Arie PA3A


-----Oorspronkelijk bericht-----
Van: Ed K1EP [mailto:k1ep.list at gmail.com] 
Verzonden: zondag 19 oktober 2008 20:49
Aan: Arie Kleingeld PA3A; elecraft at mailman.qth.net
Onderwerp: RE: [Elecraft] N1MM and K3 interface ?


At 10/19/2008 02:44 PM, Arie Kleingeld PA3A wrote:
>My settings with N1MM:
>
>DTR and RTS both to Always on.
DTR and/or RTS key the radio.  Set them to OFF if you are not using 
them for PTT or CW.



>RS 232 speed etc is set to  38400 - N - 8
>- 1
>
>CW Keying is done by the Winkey, and PTT is done by the Winkey aswell.
>The Winkey PTT is connected to the PTT-in of the K3. CW paddle (the 
>panic solution :-)) is connected to the Winkey.
>
>73
>Arie PA3A
>
>