[Elecraft] PA and FP temperature on VFO B display line

[Marek Garwolinski SQ2GXO]

If you have old firmware, you may need to enable TECH mode.
It is not needed in FW starting from MCU 2.31 / DSP 1.89

73,
Marek SQ2GXO
K3 #1329

2008/10/17 Andrzej Oskedra <sp9nh at neostrada.pl>:
> Hi;
> I have not PA and FP temperature display on VFO B line, left are OK.
> What I have to do to switch ON these parameters?
> vy 73;
> Andy SP9NH
> K3 S/N  1334
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>