[Elecraft] K3 TECH MD

[Jim Miller]

I'm new at this but occasionally I like to watch the PA temperature for example.  Unless I am wrong, I have to be in Tech Mode to see the PA TEMP display but I usually end up grabbing the wrong knob and screwing up the tamp calibration.  I would prefer that the calibration adjustments were in a separate menu from the display options.  In this example, the PA temp would be in 2 menus, tech mode to adjust calibration and either menu or config for monitoring.

73, Jim
  ----- Original Message ----- 
  From: David Lankshear 
  To: elecraft at mailman.qth.net 
  Sent: Thursday, October 16, 2008 5:52 PM
  Subject: [Elecraft] K3 TECH MD


  I've noticed that quite a few enquiries have been resolved by advising the enquirer to turn TECH MD to ON.  

  I just wonder if there's any argument to support ever having TECH MD turned OFF?  Might it be just as well to set it permanently ON in a future firmware release, thus nipping many queries-yet-to-be-raised, in the bud, and maybe eliminating an unnecessary user option?

  If I remember correctly, having read the reflector diligently, this was the very first firmware option I changed.

  73  DaveL  G3TJP

  K2/100 #5551
  K3/100 #1122


------------------------------------------------------------------------------


  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net
  You must be a subscriber to post to the list.
  Subscriber Info (Addr. Change, sub, unsub etc.):
   http://mailman.qth.net/mailman/listinfo/elecraft    

  Help: http://mailman.qth.net/subscribers.htm
  Elecraft web page: http://www.elecraft.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081016/0f6c5abe/attachment.htm