[Elecraft] Help needed, ERR VCO

[Ian Maude]

Maarten van Rossum wrote:
> Hello All,
>
> Last week I put together my K3 serial number 1849. Right after the
> first calibration I ran into a problem. The display showed ERR VC4 E
> 00039.
> After contacting Elcraft I got an email from Garry explaining to me
> how I could fix the problem by spreading the turns on the T1 VCO
> inductor on the KSYN3 board.
> Today I was able to try and fix the error and I followed Garry's
> instructions to the letter.
> Did it help? I'm not sure. I don't get the ERR VC4 E 00039 massage
> anymore but insted I get an ERR VCO E 00178 message.
>   
You probably spread them too much Maarten.  It is quite critical.

73 Ian
> I have to wait another day to contact Garry but maybe one off you guys
> can help me out.
>
> Thanks,
>
> Maarten
> PD2R
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>   


-- 

Ian J Maude, G0VGS
SysOp GB7MBC DX Cluster
Member RSGB, GQRP
K2 #4044 |K3 #455