[Elecraft] k3 : Split Operation

[David Ferrington, M0XDF]

I don't know if it would be possible to switch which VFO is used, but  
I'd like to be able to tune VFOB with the larger knob in split, since  
I'm trying to find the frequency the DX is listening on.
Yes, I know I can switch A/B, but I want to spot the frequency and Tx  
without having to press a button and delay
-- 
Being a System Administrator is like being a plumber.
If you do a good job, nobody knows. If you screw up, everybody gets  
covered in s**t!

On 8 Oct 2008, at 13:34, Cady, Fred wrote:

> Another thing about split operation is that the K3 defaults to using
> VFO B for transmit and A for receive. In the K2 A/B (I think) reverses
> these. This is a bit of a problem if you are using N1MM and running in
> split mode and tuning VFO A around. If you tune more than 300 Hz N1MM
> will toggle from Run to S&P mode. The workaround is to either widen  
> the
> CW tolerance (Config -> Other) or turn off the Run/S&P Toggle (Alt- 
> F11).
> (Thanks to K3CT for pointing this out to me.) Not a big deal but maybe
> being able to switch which is the transmit and which is the receive  
> VFO
> in split mode would be nice.
> Cheers,
> Fred, KE7X