[Elecraft] K3 HRD lastest beta not working with LP-Bride

[Larry Phipps]

OK Simon. I added support for AG$, IS, MD$, OM, RG$, RVA, RVF and RVR to 
LP-Bridge. That seems to allow HRD to work properly, at least for the 
commands that you appear to have added to the main polling routine. I 
will look through the dev reflector for further new commands that need 
to be added. I pass all your new SET commands through, so I only need to 
be concerned about new GET commands at the moment.

After a little testing, I will release this version, but I will leave 
the current version on my website as well for those who are not running 
the K3 beta firmware.

73,
Larry N8LP

> ----- Original Message ----- 
> From: "Simon (HB9DRV)" <simon at hb9drv.ch>
> To: "Larry Phipps" <larry at telepostinc.com>; <elecraft at mailman.qth.net>
> Sent: Monday, October 06, 2008 12:41 AM
> Subject: Re: [Elecraft] K3 HRD lastest beta not working with LP-Bride
>
>
>   
>> > Hi Larry,
>> >
>> > Here's 1989 - 
>> > http://mannindustries.net/hrd/public/betas/041/HRDv041b1989_Full.exe
>> >
>> > This implements everything available in Wayne's CAT support, as the radio 
>> > stays in K31 all the time I hope your bridge is no longer broken - let's 
>> > see.
>> >
>> > Simon Brown, HB9DRV
>> > www.ham-radio-deluxe.com
>> >
>> > ----- Original Message ----- 
>> > From: "Simon (HB9DRV)" <simon at hb9drv.ch>
>>     
>>> >>
>>> >> New kit in about 30 minutes, I'll be in K31 mode all the time (as 
>>> >> pre-1988) with the exception of the FW command where I'll send 
>>> >> K30,FW;K31;.
>>> >>
>>>       
>> > _______________________________________________
>> > Elecraft mailing list
>> > Post to: Elecraft at mailman.qth.net
>> > You must be a subscriber to post to the list.
>> > Subscriber Info (Addr. Change, sub, unsub etc.):
>> > http://mailman.qth.net/mailman/listinfo/elecraft
>> > Help: http://mailman.qth.net/subscribers.htm
>> > Elecraft web page: http://www.elecraft.com 
>>