[Elecraft] K3 problems

[Greg - AB7R]

Scott,

Once you installed the replacement SYN board, did you complete the VCO calibration 
and then the TX Gain calibration procedures as well as setting the reference 
oscillator frequency?

-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065


On Mon Oct  6 15:47 , wsm at amaonline.com sent:

>Hello
>When I put my K3/10/kit together it would not receive or
>transmit. Working with Gary at Elecraft we decided that the
>synthesizer board was bad. They sent me a new one and now
>I have receive and the K3 wattmeter shows full output in
>cw mode, but my external wattmeter shows very little output.
>The needle shows less than the needle width of output. 
>There is nothing wrong with the external watt meter because
>it works fine with my K2.
>I am not getting any error messages as I was before changing
>the synthesizer board.
>Any ideas?
>Thanks
>Scott N5SM
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com