[Elecraft] K3 - LO CUT/HI CUT bugs

[Rich]

Is this really a case that something is broken or is it that the operation
needs to be explained better? 
If you set the BW to a very narrow width, THEN, switch over to adjust the HI
and/or LO CUT, things seem to work as I would expect. 
It appears to me that the HI/LO CUT is associated with the center frequency
and not that the LO cut is associated with the HI CUT or vice versa.
Since the K3 has a minimum (minimal) amount of front panel controls some of
the controls function is counter intuitive.

Rich,
KE0X


Joe Planisky wrote:
> 
> Up until recently, I had only used the SHIFT/WIDTH functions for  
> setting the DSP filter parameters.  This morning I decided to try the  
> LO CUT/HI CUT functions.  I really don't understand the behavior I'm  
> seeing and I suspect there's something wrong.
> 
> 
> 

-- 
View this message in context: http://n2.nabble.com/K3---LO-CUT-HI-CUT-bugs-tp1581668p1582877.html
Sent from the Elecraft mailing list archive at Nabble.com.