[Elecraft] Stiffening VFO B knob

[Joe Planisky]

Dick,

There should already be a felt washer under the VFO B knob (at least,  
there is on mine.) To increase the friction, just use an allen wrench  
to loosen the two set screws and position the knob a little closer to  
the front panel.

73
--
Joe KB8AP

On Nov 25, 2008, at 10:18 PM, Richard S. Lindzen wrote:

> I'm personally okay with the front panel design, but I wish the VFO  
> B knob had a bit more friction.  Is there any recommended way of  
> adding this?  Should I just try to cut a felt pad and place it  
> between the knob and the panel?
>
> Dick Lindzen, KA1SA
> 301 Lake Avenue
> Newton, MA 02461 USA
>
> 1-617-332-4342
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com