[Elecraft] KRX3 No signal from main antenna

[W2LE]

Solved - in case anyone else has the same problem:  On the sub-in board 
one of the leads on T1 did not have the paint removed, looked like a 
good solder joint until I got the magnifying glass out.  Removed the 
solder, cleaned off the paint with an Xacto knife, resoldered it, now 
working like it should.

Paul  W2LE

W2LE wrote:
> Just installed my KRX3.
> With the sub receiver set to main ant, it sounds like there is no 
> antenna connected to the sub rcvr.  If I switch the sub rcvr to ATU 
> and connect the antenna to Ant 2 it works fine.
> MCU is 2.58 and DSP1 & 2 are 1.94 - just reloaded them. Did I miss 
> something?
>
> Thanks for any help.
>
> Paul  2LE
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>