[Elecraft] K2/100 Transmit Problems

[Ron McCurdy]

I have had my KPA100 installed and working properly before.  I had to remove
it to work on transmit power problems in the base K2.  All of the problems
in the base K2 were solved.  It will now transmit at 2, 5, or 10 watts on
all bands.  When I connect it to the KPA100, I get .1 watt 1-0 no matter
where the power setting is and that's on all bands.  Some bands have a
little different SWR reading but none will conduct RF.  The manual says to
check soldered joints and transformers and coils which I've done.  They all
seem to be doing fine.  Reception is no problem at all.  Where do I start to
find my problem??  

 

Ron, KE5QDA

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081123/2f86f51c/attachment.htm