[Elecraft] K3 #2184

[BigAlT]

Option 3 is NOT yet implemented in the firmware. You'll need to use Option 1
or 2.
 Al
 WB6HPF

John Ronan wrote:
> 
> Evening,
> 
> It arrived Friday, opened the box, and nearly died of fright looking  
> at all the little (and not so little packages). Weather wasn't great  
> over the weekend, so I've just finished building it.
> 
> As my first large "Kit", I thought it the instructions were quite  
> good.  However i'm stuck on one small issue.
> 
> I purchased a KTCX03-1 TXCO, and following the instructions for  
> Calibration procedure no 3. I'm not able to get anywhere. Any  
> suggestions?
> Tomorro, I will update the firmware and try again. I'm just getting  
> used to the novelty of my 20m dipole tuning from 80m to 6m. That sure  
> is some ATU.
> 
> Regards
> de John
> EI7IG
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://n2.nabble.com/K3--2184-tp1507313p1507701.html
Sent from the Elecraft mailing list archive at Nabble.com.