[Elecraft] K3 - RFC47 - Circuit diagram error

[Stewart Baker]

Well spotted Bob. The documentation always takes time to catch up.

73
Stewart G3RXQ
On Sun, 16 Nov 2008 10:03:53 -0700, Bob Cunnings wrote:
> I don't think it's an error. Inspection of the photographs in 
the
> "Elecraft K3 AF Stage Upgrade Instructions" reveals value code
> brown-black-black which is 10mH. The marking on the new part 
appears
> to be 101 which I read as 100mH.
>
> So it's just a recent change not reflected in the published 
schematic.
>
> Bob NW8L
>
> On Sun, Nov 16, 2008 at 4:19 AM, Stewart Baker
> <stewart at baker.nildram.co.uk> wrote:
>> Documentation for the  speaker mod says RFC47 is 100uH. 
However,
>> the circuit diagram is marked 10uH.
>>
>> 73
>> Stewart G3RXQ
>>
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft
>>
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com