[Elecraft] No audio from new install of KRX3

[Fredric Serota]

We are not getting any audio from the sub receiver after newly installing the KRX3. It aligned per the instructions, downloaded all new firmware ok. It set ANT=BNC. I installed the 2.7 filter in FL3, the .400 in FL4 and the .200 in FL5, mirroring the way I have the main set up. It ran the calibration procedures per the manual. However, it will not set config:VFO IND to yes, saying it is not available.
 
Any ideas where to look would be appreciated. I guess it is likely one pin is not seated properly, but the ones I can see seem to be. There are a few that are not easily visible. All cables seem correctly located.
 
Thanks in advance.
 
Fred Serota, K3BHX
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081109/3ec52e95/attachment.htm