[Elecraft] K3 - Strange Mode Problem

[Dick Dievendorff]

On each band that has a phone allocation, use the BAND button to navigate to
that band, press the MODE key enough times to get into USB or LSB, and if
it's the wrong sideband for that band then HOLD the ALT key (the left side
of the Mode button) to switch to the other sideband. You should be able to
set up 80 and 40 for LSB and the remaining bands for USB and not have to do
this again.

See the firmware release notes associated with MCU firmware version 1.65.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Fred Jensen
Sent: Thursday, November 06, 2008 5:20 PM
To: Elecraft Reflector
Subject: [Elecraft] K3 - Strange Mode Problem

This is going to have a very simple solution, and I'll feel very stupid 
about it, but I can't get my K3 to go into LSB on 75m.  Freq is set to 
3.800.000 MHz, and the radio works just fine, only cycling through the 
modes gives me USB.  No problems on 40m or 20m.  I don't operate much 
phone and it was on 80CW following the SSCW, I was working with N1MM in 
anticipation of the SSPH coming up weekend after next.

Related question:  I don't seem to be able to select opposite sideband 
on any of the other bands.  20m and down offer only USB.  Is my radio 
broken, or is this a technical difficulty in my mind.

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2009 Cal QSO Party  3-4 Oct 2008
- www.cqp.org
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com