[Elecraft] [K3]More on changing band/mode and filters don't

[hank k8dd]

More information:
I just downloaded DX4WIN demo.  It does the same thing - 
K3 on 14.025, CW, 700 Hz.  
Click on a spot for 28280.  Radio goes to 28280, Mode 
changes to SSB, but filter stays at 700 Hz.

----- Original Message ----
From: hank k8dd <hrkohl at yahoo.com>
To: Elecraft Reflector <Elecraft at mailman.qth.net>
Sent: Saturday, May 31, 2008 11:52:05 AM
Subject: [Elecraft] [K3]Changing band/mode and filters don't

I'm not sure how many use Logger32, but when I am chasing
DX spots and change band and / or mode, the filters do not go
to the default settings.  The same thing happens if I type in a
frequency.  Logger32 knows, from the band plan, which mode
to use by the frequency.
If I go from, for example - 14022, CW, 700 Hz to 7133, SSB the
K3 will not always go to the 2.7 KHz filter - sometimes it stays
on 700 Hz and sometimes it goes to the II default of 400 Hz.
I is 700 for CW and 2.7 for SSB.  II is 400 for CW and 2.7 for SSB.

The same thing can happen when I (rarely) use the Band up/down
to change bands.  If, when I go to another band, the frequency 
there is on a different mode the filter does not always go to to
that default setting.

So .... is it a firmware thing .... or is it a Logger32 thing?

73    Hank



-- 
'Never argue with an idiot. They drag you down to their 
level then beat you with experience.' -anon
--



      
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com