[Elecraft] K3 VFO A+B

[Dick Dievendorff]

You probably have linked the VFOs on 40 meters.  This was described in the
firmware release notes for MCU 1.73:

VFO LINKING: Holding the "SUB" switch links/unlinks the two VFOs. When
linked,
    VFO A is the master; turning it moves both VFOs the same amount. VFO B
can be 
    set to the same frequency by tapping A>B, or it can be offset a fixed
amount from VFO A.
    Setting them to the same frequency will permit diversity receive with
the subreceiver.


Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Peter Howson
Sent: Thursday, May 29, 2008 7:59 AM
To: Elecraft at mailman.qth.net
Subject: [Elecraft] K3 VFO A+B

Whilst playing with, sorry exploring, my K3 this morning I have set
something
that causes VFO B to track VFO A. Simply put as I tune VFO A both A & B
frequencies change together. This only occurs on 40m, the band I was
listening
to at the time. All other bands are normal. 

Unfortunately I cannot remember what I did!!!! I have been searching the
manual,
fruitlessly since lunch time.

73
Peter
GM8GAX


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com