[Elecraft] 6M issues.

[David Yarnes]

Mine works fine on 6 meters!

Dave W7AQK

----- Original Message ----- 
From: <w6jd at comcast.net>
To: "Elecraft" <elecraft at mailman.qth.net>
Cc: <support at elecraft.com>
Sent: Tuesday, May 27, 2008 1:33 PM
Subject: [Elecraft] 6M issues.


I've only recently become interested in 6M, up until now lacking
an antenna. So, today I attempted to do the TXG calibration on
50 MHz.  Using two different dummy loads I was unable to
accomplish the calibration at either power level, the result was
an indicated output power far in excess of that requested and
a very high indicated SWR (the tuner was in BYPASS mode).
Thinking that the coax length between the K3 and the load
might be an issue, I connected it directly with a male-male
connector to the K3...no difference.

With all the posts about TX shutdown on 6, has ANYONE been
able to successfully use the K# on 6 meters??

Doug
W6JD

K3/100 #23
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com