[Elecraft] K3 - 50 Hz Shift

[Bob Tellefsen]

Yes, my experience also.  50 Hz steps are too much
at the narrower DSP filter settings.  10 Hz would be
good and BW less than 200 Hz.

73, Bob N6WG

----- Original Message ----- 
From: "Roland Guidry" <guid9527 at bellsouth.net>
To: <elecraft at mailman.qth.net>
Sent: Tuesday, May 27, 2008 4:30 AM
Subject: [Elecraft] K3 - 50 Hz Shift


> Working the WPX contest this weekend, I tried using the Shift when
the DSP
> filter was as narrow as 50-100 Hz for some very weak contacts due to
QRM. K3
> performed beautifully on CW I might add, but I think the shift
adjustment in
> 50 Hz increments is too large. I would often lose the station I was
trying
> to work.
>
> I would have perferred something smaller even as low as 10 Hz. Is it
just
> me, or is this something that can be menu adjusted in the future. I
think
> this would only be needed in CW/Digital modes.
>
> Roland  NA5Q
> K3 - Serial No. 845
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com