[Elecraft] K3 interface with N3FJP FD software

[Vic K2VCO]

James C. Hall, MD wrote:

> I was setting up for using the K3 for FD this year and am having a problem
> getting N3FJP FD software to do rig control. This may belong and likely will
> go on their reflector as well, but I wanted to see if anyone else has
> noticed any problems here. In the software, I choose Elecraft as rig type
> and 4800 8-n-1 and the correct com port. Polling the rig fails. I'm just not
> sure why. I'm using a Keyspan 4-port serial to USB adapter that we've used
> successfully with the K2 for years. It will do CW keying just fine. Curious

Go to the CONFIG menu in your K3, find RS232, and set the baud rate to 
match what your computer is set to (or vice versa).
-- 
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco