[Elecraft] K2 Power Problem

[Larry Christensen]

   I was working on my new K2 Alignment and Test Part III
   All was going well until I got to the 40 Meter TX Alignment page 78
   I  followed  the  instructions but when I got to the "put K2 into TUNE
   mode  to peak the L1 I had not RF out. the display showed P.01 not the
    P2.0
   I was expected.
   I  tested  and  checked  and  could  not  find the problem. So I tried
   another band.
   This is what I found with the power out set to P 2.0
   80M P 2.0
   40M P .01
   30M P 2.3
   20M P .01
   17M P 2.2
   15M P 2.0
   12M P .01
   10M P .01

   I have 4 bands with RF out and 4 band that do not.
   I  am  missing the  common  connection  in the 4 bad bands and what to
   check next or what the problem could e.
   I have check the obvious but I am missing something.
   I  have  got  through  the  reflector  archives and have not found any
   posting with this problem

   Thanks in advance for any help

   Larry