[Elecraft] K3 ERR PL 1 storing empty memory to VFO

[Bill Coleman N2BC]

I was setting up some band edge memories (KM5Q's post of 5/10).  I goofed and hit M>V instead of V>M. Then selected an 'empty' memory position, the main freq display was "- - - -".  I hit M>V again.  The VFO jumps to 49.9940 mHz and displays ERR PL 1

Seems like the M>V routine should test for a valid frequency.

Manual frequency entry or selecting a properly setup memory brings the K3 back all OK.

I couldn't find reference to this - sorry if it's a dupe.

Using the beta firmware 1.96

73, Bill  N2BC
K3/929