[Elecraft] K3 Bandwidth SAV Not Working

[KM5Q]

It works on mine (using the current Beta firmware). However, I had to  
read the errata addition in the instructions 3 times to get it.

SUGGESTION:  I think it would be more useful to have it edit what NORM  
means so that one press of NORM would give me my preferred setting(s)  
of I/II.

For example, on CW (I have the 500Hz filter) NORM is .50. I'd rather  
begin cruising the band with a wider setting, then narrow down when I  
choose. So I'd prefer to save my NORM setting as .90. I was hoping to  
do this with SAV, but to have to then remember to turn the knob to an  
ALT, it's more trouble than just adjusting the passband wider.

Windy KM5Q
K3 #764

On Sat, 17 May 2008 12:02:33 -0400, Roy Morris wrote:
 > I would like to know if the SAV function has been temporarily
disabled in firmware.
 > This is the function that sets the bandwidth in memory and is
accessed by pushing in
 > the SHIFT knob for approx 3 seconds.  These memories are set
through <--NOR-->
 > selection.  Presently I cannot SAV new bandwidth settings.
 > Roy Morris  W4WFB  K3 #323