[Elecraft] K3 Bandwidth SAV Not Working

[Stewart Baker]

Works OK here.

73
Stewart G3RXQ
On Sat, 17 May 2008 12:02:33 -0400, Roy Morris wrote:
> I would like to know if the SAV function has been temporarily 
disabled in firmware.
> This is the function that sets the bandwidth in memory and is 
accessed by pushing in
> the SHIFT knob for approx 3 seconds.  These memories are set 
through <--NOR-->
> selection.  Presently I cannot SAV new bandwidth settings.
> Roy Morris  W4WFB  K3 #323
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com