[Elecraft] K3 has no TX audio...any ideas?

[Dick Roth]

David Wilburn wrote:
> Couple of questions;
> What is your monitor setting?
> What firmware release?
> Does the speaker work?
> Sidetone in CW?
> Did you config the speaker on?
> 
> 
> Dave Wilburn
> K4DGW
> K2/100 - S/N 5982
> K3/100 - S/N 766
> 
> "For those who fought for it, freedom has a flavor the protected will 
> never know."
> 
> 
> Dick Roth KA1OZ wrote:
>> Hi Folks--
>>
>> I finally got to reading parts of the Owner's Manual and tried to set 
>> up the rig to monitor my mic audio while in Test Mode.  I can't get 
>> either front panel Heil HM-Pro or rear panel Heil Proset 5 to pass 
>> audio.  I made sure I wasn't in Split and that the mode (USB) made 
>> sense. Regardless of whether I'm set MAIN:FP or MAIN:rP.
>>
>> Any ideas where to start first?
>>
>> ttfn &
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 

The rig is running the latest production firmware.  No problem with RX 
audio, using either speaker or phones. Yes, there's sidetone on CW.

I am seeing no deflection of compression or ALC meters.  Doesn't seem 
like the radio is hearing the mics.

Dick


-- 
"They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety."

                                              --Benjamin Franklin 1775